Zebra ZXP Series 3 Printer Driver For Linux

-
You can download driver files from here

Driver

Comments

Post a Comment

Popular posts from this blog

Install canon LBP2900 driver in linux

-
Image
1. Switch off Printer  1. install pre-install packages sudo apt-get install libcupsys2 sudo apt-get install libstdc++5 2. Download Cannon drivers from official site unzip them install packages  sudo dpkg -i cndrvcups-common_2.00-2_i386.deb sudo dpkg -i cndrvcups-capt_2.00-2_i386.deb 3. Run sudo /etc/init.d/cups restart output: [OK] 4. Run sudo /usr/sbin/lpadmin -p LBP2900 -m CNCUPSLBP2900CAPTK.ppd -v ccp:/var/ccpd/fifo0 -E 5. Run (registration of drinter in domain) sudo /usr/sbin/ccpdadmin -p LBP2900 -o /dev/usb/lp0 Output:  CUPS_ConfigPath = /etc/cups/ LOG Path = None UI Port = 59787 Entry Num : Spooler : Backend : FIFO path : Device Path : Status ---------------------------------------------------------------------------- [0] : LBP2900 : ccp : /var/ccpd/fifo0 : /dev/usb/lp0 : New!!  6. Switch ON Printer. 7.1 Backup /etc/init.d/ccpd 7.2 Run gksudo gedit /etc/init.d/ccpd and put new content for file  #!/bin/...
Read more

How to manually Factory Default E-Class Mark III (Non-Display) printers?

-
Image
To Factory Default the Datamax E-Class Mark III ('Basic' & 'Advanced') printer using its top-panel controls... Power cycle the printer: turn it off, wait 30 seconds, and then turn it back on Wait for 30 seconds, to allow the printer to boot up completely Press and hold 'Play / Pause' button until the Status (left) LED (see illustration, below) starts to flash 'RED'. The Status LED will flash orange, then green Once the Status LED starts to flash 'RED' Release the 'Play / Pause' button Wait 30 seconds Power cycle the printer, once more
Read more